But since you mentioned chatter, the problem may have to do with your hold-downs. Also, if you are milling your own wood to thickness, I recommend that you leave a sixteenth or so on the thickness before routing the lock miter. Had early problem with glue-up. For international returns, please click here. milled lumber to exact thickness and made them flat, straight and square. Same question for lap miter. Theyre also used for larger projects, including legs and posts. Ran the other two through face up in three passes. This article is from Issue 60 of Woodcraft Magazine. Agree, 45 Degree Lock Miter Router Bits | Eagle America, Lock Miter Router Bits | MLCS Woodworking, Returns of non-defective merchandise as determined by our staff are subject to a 10% restocking fee (minimum restocking fee $2.00). Warning: Make sure the router bit is properly fastened and tightened in the routers collet and the bit can rotate freely without any obstructions. Articles Can it be used with a hand drill? I used this to make legs for a 10"w x 36" long x 11" deep cypress planter out of 7/8" stock that my wife wanted 36' high on casters. Save 5% with coupon. ), Mark a centerline on your test stock. I was really impressed! Question by: Chris Twardowski on Dec 29, 2022, 3:59 PM. Set-up blocks sold separately below. Lock Miter bits are designed to create corner joints at a 90 angle where the apex of the joint is barely visible. Change to Lee Valley Canada website to see content specific to that region and the best shipping options. All Rights Reserved. Next, set up hold-downs (guide rollers or featherboards) on the infeed and outfeed fences. It is featured as part of our commitment to diversity and inclusion. Answer by: Chris - Customer Service on Oct 8, 2021, 2:17 PM. Average Customer Rating: (11 reviews) Set the piece on your router table alongside the bit. The sweet spot is the speed at which the least resonant vibration is present.
